General
Follow Section
- Failed to open the UART port, unable to connect to the configurator. How to install the driver using Zadig (Windows PC)?
- How to Import Flight Controller Configuration Files
- How to Setup DJI Air unit ？
- How does the flight controller connect with a single ESC
- How to flash firmware for a bricked flight controller?
- How to Update the Flight Controller Drivers in DFU Mode?
- What If your Flight Controller Won't Enter the DFU Mode（Windows）?
- What to do if there is an incorrect voltage reading in OSD?
- How to Calibrate Current Sensors
- The motor's abnormal sound causes jitters during flight
- Full throttle mid-air descent
- Flight Controller Installation Orientation and Inverted ESC
- Verify motor rotation and propeller installation.
- Dampening the Flight Controller.
- DFU Hijacking
- "Flight control cannot light up" troubleshooting method
- Experiencing a "Runaway takeoff" During Drone's First Flight
- How to change the color of LED strips?（INAV）
- How to read the blackbox record files of a flight controller?
- How to diagnose flight controller issues by checking the status LED when unable to connect to the Betaflight configurator?
- How to adjust channel mapping on a receiver?
- How to enable bidirectional dshot (by RPM filter) in Betaflight configurator?
- How to use the receiver Telemetry function?
- How to correctly flash firmware for Betaflight version 4.4 and above?
- How to use Zadig to solve the problem of not being able to enter DFU mode?
- How to upload OSD font for your flight controller?
- How to use GPS in Betaflight.
- How to connect the SpeedyBee F4 AIO flight controller to the SpeedyBee app?
- How to change the color of LED strips?（betaflight）
- What to do if the quad only has the first three beeps when powering up?