How to connect the F405wing series to the SpeedyBee app in WiFi mode

How to connect the F405wing series to the SpeedyBee app in WiFi mode

1，Make sure the flight controller has INAV firmware installed, and that UART6 MSP is enabled with its baud rate set to 115200.

2，Switch the flight controller's wireless indicator light to white (representing WiFi mode).

Switch the wireless mode: Press and hold the BOOT button for 6 seconds until you see the yellow light flashing rapidly. Continue switching modes until the light turns white.

3，Open the SpeedyBee app and click on the "+" icon.

4，Click on "WiFi device."

5，The WiFi page will automatically pop up. Select "SpeedyBee F405Wing."

6，Return to the SpeedyBee app page, and you should be successfully connected.