Master5 V2 Drone Firmware Flashing and Configuration File Importing

Flight Controller- Firmware Flashing and Configuration File Importing

1. Open the Betaflight Configurator。

2. Insert the USB into the flight controller, and click the “Update Firmware” at the upper right corner。

3. Select SPEEDYBEEF7V3 for the Flight Controller model, and select 4.4.0 for its version.

4. Select “Load Firmware [Online]” at the bottom right corner, and select “Flash Firmware” after successful loading.

5. Wait for the firmware to be successfully flashed. After successful flashing, click on the "Connecting" button at the upper right corner. Then click on "Apply Custom Defaults".

6. Click “Close”, and then click the “CLI” button on the left.

7. Click “Load from file” at the bottom right corner, and select the corresponding download file according to the drone version.

8. Click“Execute”

9. After the loading is complete, enter "save" in the text box below and press the "Enter" key to confirm.

ESC- Configuration File Importing

1. Open BLHeli32.

2. Insert the USB into the flight controller, power up the drone, and click Connect.

3. Click "Check" to read the ESC configuration.

4. Make sure all four ESCs can be recognized correctly, then click OK.

5. Click on ESC setup at the upper left corner, and then select "Read Setup from ini file".

6. Import the following file.

7. After importing the file, select "Write Setup".

8. After confirming that all four ESCs have been successfully written, click OK.

9. Click "Disconnect", and exit.